Belling BEL IHT60 Service Manual download pdf (Page 16)

INSTALLATION

Do Not

Do not expose this product to contamina-

tion by dust, building debris, sawdust etc,

it is recommended that this product is

stored in a clean environment until ready

to install.

Before installation any dust, building

debris, sawdust etc should be vacuumed

away to ensure no contamination will

enter the unit. Failure to follow this advice

can cause the product to fail or reduce

the life of the product.

General information

Installation should only be carried out by

a qualied installer or engineer.

Please keep to the following points most

carefully;

Although every care has been taken to

ensure this appliance has no burrs, or

sharp edges, we recommend that you

wear protective gloves when install-

ing and moving this appliance. This will

prevent injury.

The minimum distances to other appli-

ances and units are to be observed.

Wall surfaces above the work surface and

in the immediate vicinity of the cooking

hob must be heat resistant.

Laminated surfaces and the adhesive

used for xing them must be heat resis-

tant in order to avoid any damage.

The space for air circulation, located

underneath and at the back of the hob

improves its reliability by ensuring that it

will cool down, efciently.

Installations should be carried out in line

with the National Regulations applicable

with this product type.

Note: Avoid installing the appliance next

to doors and under windows. This will

avoid the potential for hot cookware be-

ing knocked off the hob when doors and

windows are opened (Risk of burns).

Built-in appliances may only be used after

they have been built-into suitable built-in

units and surfaces that meet the required

standards.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments