Belling CHIM60 Specifications download pdf (Page 9)

USING A CHIMNEY HOOD IN A REAR DISCHARGE APPLICATION

The Independent Chimney Hood can adapt to a rear discharge application with the following limitations:

A rear discharge application only works when using a 24" tall ductcover or taller. The 12" ductcover does not allow enough

room to fit the transition (with damper) and an elbow within the ductcover. The rear discharge cannot be made within the

hood itself, but rather be made in the ductcover.

Remove the screws from the back of the ductcover, followed by removing the rear panel of the ductcover. This will allow the

ducting to exit from the rear of the ductcover. (See Figure 16.)

Chimney Hood with Rear Discharge

24" DuctCover required

to fit Transition and

Elbow.

Figure 16.

Supply

Ductwork

Range

Remove

Rear Panel

DuctCover

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Belling CHIM60 Specifications Page 9